=============================================================================
List of generated methods in project: AnalogComp

THIS TEXT DESCRIPTION IS GENERATED BY THE TOOL. DO NOT MODIFY IT.
=============================================================================

Module "Cmp1"      (Component FreescaleAnalogComp)
   - Cmp1_Enable -This method enables the analog comparator.
   - Cmp1_Disable -This method disables the analog comparator.
   - Cmp1_EnableEvent -This method enables the events.
   - Cmp1_DisableEvent -This method disables the events.
   - Cmp1_GetAnalogComparatorOutputValue -This method returns current value of the analog comparator output.
   - Cmp1_SetAnalogComparatorMode -This method allows you to change the analog comparator mode (edge of analog comparator 
                output to generate interrupt) in runtime. (Method is generated only if interrupt service is enabled.)

Module "Cpu"       (Component MC9S08RC16_44)
   - Cpu_GetSpeedMode -Gets the current speed mode
   - Cpu_EnableInt -Enables maskable interrupts
   - Cpu_DisableInt -Disables maskable interrupts
   - Cpu_GetLowVoltageFlag -This method returns the flag of the Low Voltage Detect device. The flag is set when the low-voltage 
                error is detected.
   - Cpu_ClearLowVoltageFlag -This method clears the low voltage detect flag.
   - Cpu_GetLowVoltageWarningFlag -This method returns the Low Voltage Warning flag. The flag is set when the voltage subsides 
                (see electric specification of the MCU).
   - Cpu_ClearLowVoltageWarningFlag -This method clears the low voltage warning flag.
   - Cpu_GetPartialPowerDownFlag -This method returns the Partial Power Dwon flag. The flag is set when the MCU exits the 
                Partial Power Down mode.
   - Cpu_ClearPartialPowerDownFlag -This method clears the Partial Power Down flag.

===================================================================================