• SetHighSpeed - Sets the high speed mode. The method is enabled only if low or slow speed mode is enabled in the component as well.
  
  ANSIC prototype: void SetHighSpeed(void)
  
  
  
• SetLowSpeed - Sets the low speed mode. The method is enabled only if low speed mode is enabled in the component.
  
  ANSIC prototype: void SetLowSpeed(void)
  
  
  
• SetSlowSpeed - Sets the slow speed mode. The method is enabled only if slow speed mode is enabled in the component.
  
  ANSIC prototype: void SetSlowSpeed(void)
  
  
  
• GetSpeedMode - Gets current speed mode. The method is enabled only if more than one speed mode is enabled in the component.
  
  ANSIC prototype: byte GetSpeedMode(void)
  
  • Return value:byte - Speed mode (HIGH_SPEED, LOW_SPEED, SLOW_SPEED)
  
  
• SetIntVect - Sets the interrupt vector service routine. This method can be generated and used only if the interrupt vector table is generated into RAM (see options).
  
  ANSIC prototype: byte SetIntVect(word VectNo, void* ProcAddr)
  
  • VectNo:word - The number of the interrupt vector.
  • ProcAddr:void* - Address of the new interrupt handler
  • Return value:byte - Error code, possible codes:
    ERR_OK - OK
    ERR_RANGE - Vector number is out of range.
  
  
• GetIntVect - Returns the address of the interrupt vector service routine. This method can be generated and used only if the interrupt vector table is generated into RAM (see options).
  
  ANSIC prototype: byte GetIntVect(word VectNo, void* *ProcAddr)
  
  • VectNo:word - The number of the interrupt vector.
  • ProcAddr: Pointer to void* - Address of the interrupt handler
  • Return value:byte - Error code, possible codes:
    ERR_OK - OK
    ERR_RANGE - Vector number is out of range.
  
  
• EnableInt - Enables maskable interrupts
  
  ANSIC prototype: void EnableInt(void)
  
  
  
• DisableInt - Disables maskable interrupts
  
  ANSIC prototype: void DisableInt(void)
  
  
  
• GetResetSource - Gets the reset source of the last reset
  
  ANSIC prototype: byte GetResetSource(void)
  
  • Return value:byte - Reset source register.
  
  
• SetWaitMode - Sets the low power mode - Wait mode.
  For more information about the wait mode, see the documentation of this CPU.
  Release from the Wait mode: Reset or interrupt
  
  ANSIC prototype: void SetWaitMode(void)
  
  
  
• SetStopMode - Sets the low power mode - Stop mode. This method is available only if the STOP instruction is enabled (see STOP instruction enabled property).
  For more information about the stop mode, see the documentation of this CPU.
  
  ANSIC prototype: void SetStopMode(void)
  
  
  
• Delay100US - This method realizes software delay. The length of delay is at least 100 microsecond multiply input parameter us100. As the delay implementation is not based on real clock, the delay time may be increased by interrupt service routines processed during the delay. The method is independent on selected speed mode.
  
  ANSIC prototype: void Delay100US(word us100)
  
  • us100:word - Number of 100 us delay repetitions.
  
  

Note: Some methods can be implemented as macros.