| Init_EWM | |
|
|
Component
Init_EWM for COLDFIREV1
External Watchdog Monitor (EWM)
Component Level: Peripheral Initialization
Properties:
(Properties are parameters of the component. Please see the Embedded Components page for more information.)
- Component name - Name of the component.
- Device - EWM Device module
-
Settings - Common EWM module settings.
-
Clock settings - Clock/timing settings of the module.
- Compare High - This property specifies the Time-out period and the end of a window.
- Compare Low - This property specifies the begin of a window.
- Time-out period - Time-out period (for information only). This item is influenced by the Compare High property.
-
Window period - Window period (for information only). This item is influenced by the following properties: Compare Low, Compare High.
Window ends with Time-out period.
-
Clock settings - Clock/timing settings of the module.
-
Pins - Module pins/signal settings.
-
Output pin - Output pin settings.
- Pin - EWM Output.
- Pin signal - Signal name of Pin
- Pull resistor - Setting of the pull resistor.
-
Input pin - Enable/Disable allocation of the EWM Input pin.
The following items are available only if the group is enabled (the value is "Enabled"):
- Pin - EWM Input.
- Pin signal - Signal name of Pin
- Pull resistor - Setting of the pull resistor.
- Assert state - Set assert state of input pin.
-
Output pin - Output pin settings.
-
Initialization - Initialization options of the module.
- Enable EWM - Enable/Disable the External Watchdog Monitor.
-
Call Init method -
The Init method of the component may be called after a power-on or reset (in initialization code) by PE.
yes - The Init method is called by PE.
no - The Init method is not called by PE, it should be called in the user's code.