Component documentation

Device - COP device module (for information only).
Settings - Common COP module settings.
- Clock setting - Clock/timing settings of the module.
  - Settings supported for HC08 except for MR8 and MR32 derivatives.
    - Time-out period prescaler - Time-out period prescaler. This item sets the watchdog device timeout period.
      HC08AZ60: This item modifies the COPL bit in the MOR register.
      HC908AS60, HC908AS60A, HC908AZ60, HC908AZ60A: This item modifies the COPL bit in the CONFIG1 register.
      This item modifies the COPRS bit in the CONFIG1 register.
    - Time-out period - Time-out period (for information only).
      The value is calculated using this formula: Time-out period = (Time-out period prescaler)/(COP clock source)
      
      This item is influenced by the following properties: Time-out period prescaler.
  - Settings supported for Freescale HC08 MR8 and MR32 derivatives only.
    - Time-out period - Time-out period (for information only).
      The value is calculated using this formula: Time-out period = (fixed prescaler 262 128 cycles)/(COP clock source)
Initialization - Initialization options of the module
- Enable COP - Enable/disable the watchdog module.
  This item modifies the COPD bit in the CONFIG1 register.
  Note: In monitor mode, the COP is disabled if the RST pin or the IRQ1 is held at V_Hi. During the break state, V_Hi on the RST pin disables the COP.

PROCESSOR EXPERT is trademark of Freescale Semiconductor, Inc.
Copyright 1997 - 2010 Freescale Semiconductor, Inc.