# lwip_https_server

## Overview

This example shows how to use lwip and bedtls to setup a https server.

## Board Settings

- Connect a USB port on PC to the PWR DEBUG port on the development board with a USB Type-C cable
- Connect an Ethernet port on PC to a RGMII port or a RMII port on the development board with an Ethernet cable

## Project Configurations

- Ethernet Port Settings: Refer to [Ethernet common project settings](../doc/Ethernet_Common_Project_Settings_en.md)
- Ethernet DHCP Configurations
    - the configurations in the `CMakeLists.txt` as follows:
      - sdk_compile_definitions(-DLWIP_DHCP=0): Disable DHCP feature
      - sdk_compile_definitions(-DLWIP_DHCP=1): Enable DHCP feature


## Run Example

- Compiling and Downloading
- Running log is shown in the serial terminal as follows:

```console
This is an ethernet demo: https server (Polling Usage)
LwIP Version: 2.1.2
Enet phy init passed !

************************************************
 mbedTLS HTTPS Server example
************************************************
Link Status: Up
Link Speed:  1000Mbps
Link Duplex: Full duplex
IPv4 Address: 192.168.100.10
IPv4 Netmask: 255.255.255.0
IPv4 Gateway: 192.168.100.1
```

Open browser on pc, type https://192.168.100.10 and press enter, the web page will appear：

 ![https_server](doc/lwip_mbedtls_https_server.png "https_server")