PictureBoxControl5 16, 15 1028, 28 Bitmaps\DbcButton.png PictureBoxControl1 11, 16 576, 27 Bitmaps\StartButton.png PictureBoxControl4 48, 45 787, 5 Bitmaps\MoreInfo.png PictureBoxControl3 48, 45 397, 5 Bitmaps\Step.png PictureBoxControl2 48, 45 3, 5 Bitmaps\Info.png StaticTextControl16 326, 20 841, 2 Info Microsoft Sans Serif, 10pt, style=Bold Tip StaticTextControl4 307, 39 57, 144 Info The J1939 Interaction Layer is assigned to the node 'EMS'. The J1939 IL is completely configured with the database, no CAPL programming is needed. StaticTextControl11 292, 91 841, 60 Info The behaviour of the node is defined in the DBC below topic "Network nodes" by means of -node attributes (e.g. for the J1939 device name) -Tx message list (parameter groups which are supported for transmission) -message attributes (starting with "GenMsg…") -signal attributes (starting with "GenSig…") StaticTextControl10 210, 13 451, 28 Info > Press the 'Start' button ( ) in the toolbar. StaticTextControl9 1, 193 390, 4 221, 221, 221 StaticTextControl8 1, 192 780, 5 221, 221, 221 StaticTextControl7 320, 39 461, 47 Info When the measurement is started, CANoe switches to the desktop 'Measurement'. Use the context menu of the desktop tab to configure this behaviour! StaticTextControl6 302, 43 841, 28 Info > Click on the CANdb++ Editor button ( ) on the ribbon tap 'Tool' to open the assigned database. StaticTextControl5 324, 78 57, 60 Info The network contains a single node 'EMS', which can transmit the following parameter groups: -EEC1 with signal EndSpeed is transmitted cyclically -ET1 with signal CoolantTemp is transmitted on change and on request -ACL, ACKM, TPCM, TPDT which are needed in a J1939 network StaticTextControl1 54, 17 451, 3 Info Microsoft Sans Serif, 10pt, style=Bold Usage StaticTextControl3 242, 26 57, 28 Info This examples demonstrates the usage of the J1939 Interaction Layer to simulate a J1939 node. StaticTextControl2 327, 17 57, 5 Info Microsoft Sans Serif, 10pt, style=Bold Information Panel 1175, 200 Info