]> Verify proper placement of PGN within 29-bit header of all frames J1939-82 07/04 A.3.1.1 0 254 202 0 254 203 0 255 0 0 255 1 0 238 0 0 236 0 0 235 0 0 232 0 Verify DUT properly sets the EDP Bit for all 29-bit frames. J1939-82 07/04 A.3.1.2 0 254 202 0 254 203 0 255 0 0 255 1 0 238 0 0 236 0 0 235 0 0 232 0 Verify DUT properly sets the DP Bit for all 29-bit frames. J1939-82 07/04 A.3.1.3 0 254 202 0 254 203 0 255 0 0 255 1 0 238 0 0 236 0 0 235 0 0 232 0 Verify the length of the data field for all 29-bit Frames (Page 1 and 2) is 8 bytes, except for PGN 59904 frames. J1939-82 07/04 A.3.1.4 0 254 202 0 254 203 0 255 0 0 255 1 0 238 0 0 236 0 0 235 0 0 232 0 Verify proper byte ordering of the parameter data for multiple byte parameters. (e.g. Verify Address Claim data, PGN 60928). This verification also applies to -7X. J1939-82 07/04 A.3.1.5 0 238 0 Verify DUT indeed uses single CAN Frame to send PGN under this situation. Verify any unused bytes are filled with $FF. J1939-82 07/04 A.3.1.6 Setup DUT to meet the following conditions: Query node to send multipacket capable PGN with less than 9 bytes of data Verify the DUT does not send a Request message for a PGN if that PGN was received with the last 50 mS J1939-82 07/04 A.3.1.7 Setup DUT to meet the following conditions: Query node to continually send requests for Parameter Groups Verify the DUT stops sending the same Request message after the third attempt (second retry). A Request retry is issued following a Response Timeout (Tr) failure. J1939-82 07/04 A.3.1.8 Setup DUT to meet the following conditions: Query node to send requests for Parameter Groups which are not sent in response